Material Dealing with Power UNIT 1
This energy unit is created for the fork lift field, consisting of really productive gear pump, DC motor, manual increase and reduced valve, tank, ect. The up and down motion are controlled through the lever on the guide release valve, and that is equipped with an electrical switch to activate the motor. The lowing speed is managed from the pressure compensated flow management valve.
1. The duty of this electrical power unit is S3, i.e. 30 seconds on and 270 senconds off.
2. Clean all the hydraulic components concerned ahead of set up of the power unit.
3. Viscosity with the hydraulic oil shoud be 15~46 cst, which should really also be clean and cost-free of impurities, N46 hydraulic oil is proposed .
four. Oil shifting is required after the original a hundred operation hours, afterwards once every single 3000 hours.
five. The energy unit proven is intended to be mounted horizontally.
Materials Dealing with Power UNIT 2
This energy unit characteristics energy up gravity down circuit. Activate the get started solenoid to begin the motor to lift the machine. The lowing motion is activated from the solenoid valve together with the decreasing velocity controlled from the strain compensated movement management valve. Products of this series might be extensively used in the industry of logistic units for instance fork lift, mini lift table, etc.
1. The duty of this electrical power unit is S3,i.e.,thirty seconds on and 270 senconds off.
two. Clean every one of the hydraulic elements concerned just before mounting the energy unit.
three. Viscosity of the hydraulic oil shoud be 15~46 cst,which need to also be clean and cost-free of impurities, N46 hydraulic oil is encouraged .
four. Oil shifting is needed after the first 100 operation hours,afterwards after each and every 3000 hrs.
five. The energy unit need to be mounted horizontally.