Electrical power UNITS FOR LIFT TABLE one
Basic Description
This electrical power unit is intended solely for that small lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit is widely employed while in the business of logistic units including minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is managed from the solenoid valve with all the velocity managed by the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Common Description
This power unit is created exclusively for that medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve as well as the speed controlled through the adjustable needle valve. When the lift rises to a higher positoin, but the power provide is minimize, the decreasing motion is managed through the guide override perform.
Power UNITS FOR LIFT TABLE three
Basic Description
This electrical power unit is built solely for that big lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve plus the speed managed by a strain compensated flow manage valve.
Electrical power UNITS FOR LIFT TABLE four
Basic Description
This energy unit is built exclusively for your significant lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve and also the velocity managed through the adjustable needle valve. When the lift rises to a high positoin, but the energy provide is reduce, the lowering movement is controlled through the manual override function.
Unique Notes
1. This electrical power unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean all of the hydraulic elements concerned ahead of installation of the power unit.
3. Viscosity from the oil shoud be 15~46 cst,which ought to also be clean and totally free of impurities.N46 hydraulic oil is encouraged.
four. Oil changing is needed just after the original 100 operation hours,afterwards as soon as every 3000 hrs.
five. The electrical power unit shown is designed to be mounted vertically.